How to Solve and Prevent Pachislo Slot Machine Coin Jams

Pachislo Coin Jam Prevention and Solutions

Square Plastic Brown or Black Coin Mechanism

1. Turn machine off.

2. Evacuate the base coin shield. Now and again the square darker coin systems have coin shields that are pivoted – simply bring down the coin shield. The dark renditions have removable coin shields. Press in on the left and ideal to evacuate.

3. The coin way is secured by a spring stacked region. Look carefully and you can without much of a stretch see the spring in the photograph. Force the spring stacked zone up – it really climbs and to the upper right.

4. Clear the coin with your finger.

On the off chance that the coin is stuck in the acceptor on the front of the machine and you can see it, give pulling a shot of the front. On the off chance that it is stopped where you either can’t see it or can’t expel it, pull open the spring stacked region and put in another token and push it UP to push remove the coin and draw it up through the front. Walk out on and reset if necessary.

The more extended metal variants work a similar way and will likewise have a spring stacked front.

Forestalling Coin Jams

Most coin jams are not the consequence of issues with your machine but rather of tokens and earth.

All Pachislos acknowledge .984″ tokens as it were. Despite the fact that your tokens may seem, by all accounts, to be a similar size, a slight variety long or width might be sufficient to cause coin jams.

Coin components can turn out to be VERY messy after some time. This made the tokens move gradually through the coin way and wind up noticeably stuck in the coin instrument or the coin chute and never fall into the container. Take after these means to counteract future coin jams:

1. Check for Magnetic Tokens

Before you utilize tokens in your machine run a magnet over them and expel any attractive tokens. Many machines will kick out or stick attractive tokens and after that send a blunder code.

2. Check Token Sizes

Most Pashiclos just acknowledge .984″ tokens. The greater part of your tokens may seem, by all accounts, to be indistinguishable is estimate, however your machine might be specific. Anything other than.984″ will wind up noticeably stuck. Put the tokens in little stacks and check whether any are somewhat bigger or thicker than the others and evacuate them.

3. Clean the Tokens

Utilize Kaboom more clean. Blend a little in a can of warm water. Drop your tokens in and blend them for a couple of minutes. Flush them and dry them before utilizing. In the event that you utilize your machine regularly do this at regular intervals or so to counteract earth development in the coin instrument, coin way and container.

4. Clean the Mechanism

Evacuating the component is basic. Unplug and evacuate it and clean it well with a wet wipe, lifting the spring stacked territory and cleaning there also. In the event that the metal coin way is rusting utilize a sharp blade, screwdriver or exacto blade to evacuate however much rust as could reasonably be expected and clean the rust with a wipe. When you are done give the way a VERY SMALL squirt of silicone shower, wiping off any overabundance.

5. Clean the Coin Chute and the Coin Acceptor

While the coin system is out, clean the outside coin acceptor where the coins enter the machine. In the event that you have wet wipes take a stab at utilizing a thin blade to push a wet wipe delicately into the coin acceptor from the outside of the machine and hauling it out the opposite side to clean within. When you are fulfilled shower one squirt of silicone splash into the coin acceptor, wiping off any abundance silicone.